dungeon creation help

6 replies · 1,659 views · Started 02 September 2006

stev1392 02 Sep 2006, 01:01

I just finished the first dungeon in my first quest, but when I went to test it, I was only able to get through about half of it when I came to a door in the dungeon, It wouldnt let me go through it. It was'nt a locked door or anything, just an open door way. I checked to see if it was connected and everything seems to suggest it should be working, but it's not. Please help.😕

Rakki 02 Sep 2006, 03:30

Are you sure you placed the door with the Doors tool (F6) and you didn't accidentally place it yourself, with combos?

The_Amaster 02 Sep 2006, 17:19

I also have two tips.
Make sure that the Dmap level is higher than 1(I dont know why, but this is a source of many problems), and in ZQuset hit "W" to check where you can and cant walk.

LinkMaster500 02 Sep 2006, 22:06

For dungeon DMaps, the level number actually has to be greater than zero for things to work properly. You could use a level number up to 255, but level numbers 1-8 are reserved for Triforce pieces.

bluedeath 05 Sep 2006, 14:09

try moving the dmap around with the scroller below it make sure it shows the whole level map but u will have to change the continue and all the warps

mirror_shield33 17 Sep 2006, 14:54

Here's an idea. Check to see if the dmap fits on the actual map. It could be that one of your rooms isn't on one of the two screens.

The_Amaster 18 Sep 2006, 00:18

I think Bluedeath's is the most likely. Many times I've had that happen to me. Let me guess, the door goes to the right. Am I correct?