Whistle Warp problem

Maybe the cause is the fact that the DMAp you sent it to is a dungeon. That threw me off alot too... Just check the DMap and check the warp manually by getting the cordinates. (SP?)

It's not set to Dungeon. It's set to Overworld. Maybe the places it takes me are the locations of the dungeons in the original quest... Oh well. I don't think I'll use them then.

fill it in, in the misc data area under whistle warps

Errr.....

Freedom, I already said that when I test the warp, I don't go to trhe right screen. If I try to do screen 27, it instead takes me to screen 0B.

Then your slider must be wrong on your dmap, set the dmap to dungeon, fix the slider, and then set it back to overworld

I did fix it. It changes NOTHING.

Why don't you try reading the tutorials?
When people just ram on and try to figure things out for themselves they end up getting things so out of whack NOBODY can fix it.

Um, I can't find ANY tutorials....

It's because like before, you're too lazy to look.
good luck.

I am not too lazy to look! Sometimes, I just don't care about things and give up at them. Like right now. If I can't get this to work, I'll just forgo using it.

Maybe you should go to Zelda Classic School and you'll learn all these things!

Settle down, children. :tongue: (Then again, I'm probably younger than any of you anyway...) (For I'm 14...)

Anyway, pikaguy's problem is that clicking Go in ZQuest for the whistle warps doesn't work. Well, to be honest, it actually does not work! Yes, the testing button doesn't work. At least for me, too, anyway. But you'll have to test it in your actual game in ZC to verify its... correctness. (Is that a word?)

EDIT: Testing it, clicking Go in ZQuest for #1 brought me to #5, #2 brought me to #6, and so on. #5 brought me to #9 (in which case 9 isn't used at all :laughing: ). #6, 7, 8, and 9's Go buttons brought me to some random screens... 😮dd:

EDIT #2: Okay, so pikaguy is exactly one month younger than me. 🙄 But you get the picture. 😉