ShadowTiger
12-27-2006, 09:24 PM
Note quite sure if this is true to the later betas or to ZC in general, so I'll just stick it here.
This is a little bit weird. Long story short, I'm swapping SFX's, and I replaced the 350 something KB default SFX.dat with my own 1.5 MB sfx.dat. I replace it. There is nothing with the name "sfx" in it other than "sfx.dat" and it is the only one, and it is not the default. The shortcut I'm using is the one pointing to the ZC in the same folder I replaced the sfx.dat file with. I start up ZC via the shortcut or the ... well, what the shortcut is pointing to, and play a specific quest, it acts as if it's holding the original sfx.dat rather than the new one, yet it's operating off of a fresh start with the new sfx and the old one nowhere in sight nor reference.
So, basically, I think that the custom sfx area of ZQuest has overriden the sfx.dat. Is there a way to reset this?
This is a little bit weird. Long story short, I'm swapping SFX's, and I replaced the 350 something KB default SFX.dat with my own 1.5 MB sfx.dat. I replace it. There is nothing with the name "sfx" in it other than "sfx.dat" and it is the only one, and it is not the default. The shortcut I'm using is the one pointing to the ZC in the same folder I replaced the sfx.dat file with. I start up ZC via the shortcut or the ... well, what the shortcut is pointing to, and play a specific quest, it acts as if it's holding the original sfx.dat rather than the new one, yet it's operating off of a fresh start with the new sfx and the old one nowhere in sight nor reference.
So, basically, I think that the custom sfx area of ZQuest has overriden the sfx.dat. Is there a way to reset this?