PDA

View Full Version : Whistle Warp problem


Nimono
12-12-2005, 08:14 PM
When I try to set whistle warps and click go so I can test the warp, it doesn't take me to the screen I set. Instead, it sets me on a different screen (I.e, if I set the warp to screen 27, it takes me to screen 0B instead). What's going on here?
SpacemanDan
12-12-2005, 08:29 PM
Maybe the cause is the fact that the DMAp you sent it to is a dungeon. That threw me off alot too... Just check the DMap and check the warp manually by getting the cordinates. (SP?)
Nimono
12-12-2005, 08:32 PM
It's not set to Dungeon. It's set to Overworld. Maybe the places it takes me are the locations of the dungeons in the original quest... Oh well. I don't think I'll use them then.
Freedom
12-12-2005, 08:59 PM
fill it in, in the misc data area under whistle warps
Nimono
12-12-2005, 09:02 PM
Errr.....
Nimono
12-12-2005, 09:03 PM
Freedom, I already said that when I test the warp, I don't go to trhe right screen. If I try to do screen 27, it instead takes me to screen 0B.
Freedom
12-12-2005, 09:21 PM
Then your slider must be wrong on your dmap, set the dmap to dungeon, fix the slider, and then set it back to overworld
Nimono
12-12-2005, 09:22 PM
I did fix it. It changes NOTHING.
Freedom
12-12-2005, 09:34 PM
Why don't you try reading the tutorials?
When people just ram on and try to figure things out for themselves they end up getting things so out of whack NOBODY can fix it.
Nimono
12-12-2005, 09:34 PM
Um, I can't find ANY tutorials....
Freedom
12-12-2005, 09:38 PM
It's because like before, you're too lazy to look.
good luck.
Nimono
12-12-2005, 09:40 PM
I am not too lazy to look! Sometimes, I just don't care about things and give up at them. Like right now. If I can't get this to work, I'll just forgo using it.
cbailey78
01-07-2006, 07:05 PM
Maybe you should go to Zelda Classic School and you'll learn all these things!
Pineconn
01-07-2006, 09:44 PM
Settle down, children. :tongue: (Then again, I'm probably younger than any of you anyway...) (For I'm 14...)

Anyway, pikaguy's problem is that clicking Go in ZQuest for the whistle warps doesn't work. Well, to be honest, it actually does not work! Yes, the testing button doesn't work. At least for me, too, anyway. But you'll have to test it in your actual game in ZC to verify its... correctness. (Is that a word?)

EDIT: Testing it, clicking Go in ZQuest for #1 brought me to #5, #2 brought me to #6, and so on. #5 brought me to #9 (in which case 9 isn't used at all :laughing: ). #6, 7, 8, and 9's Go buttons brought me to some random screens... :odd:

EDIT #2: Okay, so pikaguy is exactly one month younger than me. :rolleyes: But you get the picture. ;)